Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
DuraFlex Chimney Cleaning in Flatbush, NY
We provide independent DuraFlex service across Flatbush, and we are not affiliated with or authorized by the manufacturer. What makes DuraFlex work here different is what these liners vent: mostly gas-fired boilers and water heaters in pre-war rowhouses, not fireplaces. That changes the inspection, the testing, and the failure modes we look for. Our technicians have up to 12 years of experience with flexible stainless liner systems. Call (855) 301-8570. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.

Why Flatbush Residents Choose Us for DuraFlex Service
DuraFlex is one of the flexible stainless liners we work with regularly, and we know where these systems fail in Flatbush’s housing stock. The liner itself is rarely the problem. The connections, the bottom joint, the top plate, and the chase around it are what give out. We approach a DuraFlex job as a full-system question: appliance, connector, liner, cap, and the masonry chase it all sits in. A chimney is a system, and we inspect and service every component, not just the flue.
We use quality parts that fit DuraFlex equipment, including OEM liner sections, top plates, and caps where a repair or extension calls for them. Scheduling is straightforward. Tell us what the appliance is doing, what you’ve noticed at the cleanout, and whether the chase is shared, and we’ll book the right kind of visit rather than a generic sweep. Homeowners on the rowhouse blocks off Flatbush and Church Avenues deal with the same boiler-flue realities, and we plan the work around them.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Common DuraFlex Chimney Cleaning Problems We Solve in Flatbush
These are the DuraFlex issues we run into most often in Flatbush, and each one has a local cause behind it.
- Condensate corrosion at the bottom joint. Gas boiler flue gases cool as they rise through an uninsulated exterior chase, and the moisture pools at the liner’s lowest joint. In Flatbush’s cold, damp winters, when boilers cycle hard from November through March, that joint can corrode through and start leaking at the basement cleanout.
- Crushed or separated liner sections. Oversized sweeping brushes and debris impact damage ovalized DuraFlex runs installed through offset coal-era flues. Once a section is crushed, draft suffers and the liner no longer fits the appliance it vents.
- Top-plate and cap corrosion. Humid summers accelerate masonry spalling on exposed Flatbush brick stacks, and winter freeze-thaw works the top plate loose. Water then tracks down the liner annulus and shows up as staining or rust far below the roof.
- Loose or missing liner-to-appliance connectors. Behind finished basement walls, a disconnected connector goes unnoticed until a gas water heater or boiler short-cycles in a cold snap and spills combustion gases into the basement instead of up the flue.
- Undersized or wrong-profile liners. When an old coal flue was relined for a modern gas appliance, the liner has to match that appliance’s venting needs. A run sized for the wrong appliance drafts poorly and is a candidate for replacement rather than another patch.
DuraFlex Service in Flatbush: What Local Conditions Mean for Your Equipment
On the rowhouse blocks off Flatbush Avenue, the boiler usually sits in a basement or rear extension, and its chimney rises through a shared party-wall stack. That single fact shapes nearly every DuraFlex job here. The boiler flue and a neighboring unit’s flue often share one masonry chase, which means a standard sweep can dislodge soot or a broken liner fragment into the adjacent flue. So a camera-assisted Level 2 inspection and a shared-chase CO test come first, before any brush goes in. We want to see the whole chase, confirm what ties into it, and pressure-test for spillage while the appliance runs. Only then does cleaning make sense. On these Flatbush blocks, that order of work protects the neighbor’s flue as much as yours, and it’s how we tell whether a problem is yours alone or shared with the unit next door.
DuraFlex Models & Products We Service in Flatbush
We service the full range of DuraFlex flexible stainless liner products found in Flatbush buildings: smooth-wall liner kits, double-wall flexible liner series, oval profiles sized for tight masonry flues, and contractor-grade flexible stainless kits. Each type has its own wear pattern. Smooth-wall runs resist soot buildup better but still corrode at the bottom joint when condensate sits. Oval runs through offset coal-era flues are the ones most likely to be crushed by an oversized brush. When we replace or extend a run, we choose OEM DuraFlex liner sections, top plates, and caps so the UL listing and clearances stay intact. Quality aftermarket clamps and connectors are fine where they meet the same spec. We fit the part to the appliance and the chase, not the other way around.
See the difference
Before
After
Before
After
Before
AfterDuraFlex Service Pricing in Flatbush
DuraFlex work is priced per job by a written estimate, and the estimate is free. What drives the number is the scope: a camera-assisted Level 2 inspection and shared-chase CO test is one kind of visit; replacing a corroded bottom joint with an OEM DuraFlex section and a new cap is another; a full liner replacement for a crushed or undersized run is a larger project. Chimney waterproofing and cap replacement are quoted on their own when the stack condition calls for them.
You’ll get a written price before any work is booked, and we tell you plainly when a repair can safely wait. Call (855) 301-8570 for an exact quote. Estimates are free.

Serving Flatbush, NY – Our Local Coverage Area
We serve Flatbush and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – DuraFlex Chimney Cleaning in Flatbush
Yes. A gas-fired boiler still produces soot, debris, and moisture that collect in the liner and at the bottom joint, even though there’s no wood creosote to worry about. In Flatbush’s cold months, when the boiler runs hard, that buildup and the condensate it traps are exactly what we check for. An annual inspection keeps the connector, liner, and cap in view. Call (855) 301-8570 to book one. Estimates are free.
The cap corrodes because water and humid air are reaching it, usually helped along by masonry spalling on an exposed brick stack and winter freeze-thaw working the top plate loose. Once the seal at the top breaks, moisture tracks down the liner annulus and the cap keeps failing. We check the crown, the top plate, and the cap together, and we can address all three. Call (855) 301-8570 for an exact quote. Estimates are free.
Yes, but it has to be done with the shared chase in mind, not as a one-unit job. Because a Flatbush party-wall stack can carry both your boiler flue and a neighbor’s, a camera-assisted Level 2 inspection and a CO test of the shared chase come before any work. We confirm what ties into the stack so a repair on one side doesn’t disturb the other. Call (855) 301-8570 to talk through your building. Estimates are free.
A metallic rattle on startup, soot stains at the basement cleanout, rust streaks on the liner, or a cap that’s pulling loose all point to service. These signs often mean the bottom joint has corroded where condensate collects, or a connector has come loose behind a finished wall. Don’t wait on a rattle. Call (855) 301-8570 for an exact quote. Estimates are free.
Repair when a single joint, cap, or connector is the failure; replace the full run when the liner is crushed, unlisted, or sized wrong for the gas appliance it now vents. A camera inspection tells us which case you’re in. We show you what the camera sees so the decision is yours to make with real evidence. Call (855) 301-8570 for an exact quote. Estimates are free.
Service Areas Near Flatbush
We also serve homeowners and building owners in nearby Williamsburg, Bedford-Stuyvesant, Clinton Hill, Prospect Heights, Fort Greene, East Flatbush, and Crown Heights. If your building sits just outside Flatbush, the same gas-boiler flue and shared-chase considerations apply, and we plan the visit the same way. Read more about our DuraFlex work and how we approach these systems.
Book Your DuraFlex Service in Flatbush Today
Whether it’s a rattle on startup, a corroded cap, or a liner you’re not sure about, we’ll tell you what we find and why it matters for your safety and your home’s integrity. Call (855) 301-8570 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Williamsburg.