Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Flatbush
If your chimney is spalling, your crown is cracked, or water is showing up on a ceiling near the stack, we can help. Chimney Sweep Williamsburg handles chimney repair in Flatbush as full-system work: flue, crown, flashing, brick and liner, checked together and fixed by one company. Flatbush rowhouses don’t fail the way suburban fireplaces do. Here the chimney usually serves a gas boiler on a shared stack, so a masonry problem and a draft problem are often the same problem. Our technicians have up to 12 years of experience, and the local pro we connect you with is licensed and insured as their state requires. Call (855) 301-8570 for a free estimate. We answer 24/7.
Why Flatbush Homeowners Call Chimney Sweep Williamsburg for Chimney Repair
Flatbush is dense, and the buildings here are old. Stacks rise through party walls between attached rowhouses, boilers sit in basements or rear extensions, and many flues were built for coal and then converted to gas without anyone resizing them. We plan every repair around that reality, which is why a sweep here so often turns into a shared-flue and carbon monoxide check before any mortar goes on a trowel.
That approach builds a strong reputation in Flatbush, because we tell you what we find and why it matters for your safety and your home’s structural integrity. Nothing gets recommended without camera evidence or photos you can look at yourself. If a flashing repair can safely wait until spring, we say so.
We serve rowhouse blocks off Flatbush Avenue and Church Avenue, and the walk-ups and small apartment buildings in between. Roof access on these streets is tight, scaffolding is expensive, and nobody wants a neighbor’s quiet morning wrecked by a crew working a shared stack. We plan the job for the building you actually live in.
Pricing is set per job by a written estimate, and the estimate is free. The local pro we connect you with works with professional-grade materials from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco and Copperfield, the same manufacturers specified across the chimney trade.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Repair Services in Flatbush
Mortar Repointing
Mortar joints on an exposed Flatbush stack take decades of freeze and thaw, and the joints usually go before the brick does. Repointing means cutting out the failed mortar and replacing it with a mix matched to the original brick, so the wall stays flexible and water can escape. Do this early on a Flatbush rowhouse and you spare yourself a rebuild.

Spalling Brick Repair
Flatbush’s humid summers push moisture into exposed brick, and that moisture drives spalling, where the face of the brick shears off. Once the face is gone the brick absorbs more water and the cycle speeds up. We replace spalled units with matching brick and correct the moisture path that caused the damage in the first place, usually at the crown or flashing.

Chimney Waterproofing
A breathable waterproofing treatment on a Flatbush masonry stack slows water absorption without trapping vapor inside the brick. It’s a small piece of the budget compared with rebuilding the stack. We only apply it once the crown and flashing are sound, because sealing over a leak just hides it.

Flashing Repair
Most water that enters a Flatbush chimney gets in where the stack meets the roof. Failed flashing on an attached rowhouse often leaks into a neighbor’s ceiling as easily as your own. We reseat, replace and seal the flashing with properly stepped metal, which is the repair that actually stops the leak.
Chimney Rebuilding
When spalling has eaten through the top courses of a stack or the mortar is too far gone to repoint, the section above the roofline gets rebuilt, and on rowhouse blocks that often means working a shared party-wall stack. This is a structural repair, so we scope it carefully with camera evidence and a written estimate before anyone goes up. On a Flatbush rowhouse the goal is always to rebuild only what has failed, not to sell a whole-stack replacement you don’t need.
Trusted Brands We Service in Flatbush
We install and work with Gelco, Olympia Chimney and Famco products, and the DuraFlex, HeatShield and Copperfield lines used across the trade. That matters for a Flatbush rowhouse, because relining a boiler flue or resurfacing a deteriorated liner calls for a system the manufacturer specifies, not a hardware-store substitute. HeatShield ceramic resurfacing, in particular, lets us restore a pitted flue interior where a full reline isn’t needed. We don’t stock parts on a truck, and we won’t pretend otherwise; the estimate names the system, and the material is ordered for your job. Fast turnaround, professional-grade parts, one company handling the whole life of the chimney.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Repair Problems We See in Flatbush Homes
- A neighbor’s appliance tied into the same chase. In Flatbush’s attached rowhouses, two or three flues often share one party-wall stack. When a neighbor’s boiler vents alongside yours, a repair on your flue can change their draft, and theirs can push carbon monoxide back down your stack. That’s why we test the whole chase, not just your side.
- A coal-era flue behind finished walls, now serving gas. Many Flatbush chimneys were built unlined or with clay tile to vent coal, then converted to gas boilers and water heaters. An oversized or disconnected liner on a modern gas appliance spills flue gases into the basement. A camera inspection is the only honest way to know.
- Spalling brick from damp summers. Flatbush’s humid summers drive moisture into exposed brick stacks and accelerate spalling, and the failure spreads from the top courses down. Look for crumbling faces and crumbling mortar at the roofline.
- Cracked crowns and leaking flashing on shared roofs. The crown takes the weather and the flashing takes the runoff, and when both go, water travels the shared masonry into more than one unit. Both get checked together, because fixing one without the other is a known way to fail twice.
Here’s the piece most Flatbush homeowners don’t hear from a sweep crew. On the rowhouse blocks, the chimney stack is rarely a single flue. Party-wall chases commonly carry two or three flues serving different units’ gas boilers, so a repair on one flue can affect a neighbor’s draft and raise the carbon monoxide risk in a building you don’t control. That’s why a routine sweep on a shared Flatbush stack turns into a Level 2 inspection. A qualified technician typically performs spillage tests at the draft hood, verifies liner sizing for the gas appliance, and then addresses the spalling or crown masonry before the heating season peaks. We tell you what we find and why it matters for the whole building, not just your unit.
Pricing for Chimney Repair in Flatbush, NY
A chimney repair in Flatbush usually costs between a few hundred and several thousand dollars, depending on how much of the stack is involved. Repointing is the cheapest masonry fix; a section rebuild at the roofline is the most expensive. The written estimate sets the final price, and the estimate itself is free.
| Repair | Typical Flatbush Range |
|---|---|
| Mortar repointing (spot, at the roofline) | $300 – $650 |
| Flashings resealed or stepped metal replaced | $350 – $900 |
| Crown rebuild or waterproofing the stack | $400 – $1,200 |
| Spalling brick replacement (limited) | $450 – $1,500 |
| Sectional chimney rebuild above the roofline | $2,500 – $7,500 |
Scaffolding and tight roof access on Flatbush’s attached blocks can push a job toward the top of a range. On a shared party-wall stack the scope may cover a neighbor’s flue too, so we price exactly what the camera shows. Call (855) 301-8570 for an exact quote. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
We Also Serve Cities Near Flatbush
Flatbush borders some of the busiest rowhouse streets in the borough, and our work covers those too. We serve Flatbush along with East Flatbush, Crown Heights, Prospect Heights and Park Slope. If you live off the same shared roofline as a Flatbush chimney we’ve worked on, call and we’ll talk through yours. Estimates are free.
Serving Flatbush, NY – Our Local Coverage Area
We serve Flatbush and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Repair in Flatbush
You know by testing it, not guessing. On a shared Flatbush stack, a technician performs a spillage test at your draft hood and inspects the party-wall chase with a camera, so you can see whether the two flues are actually connected or leaking into each other. We show you the evidence before recommending anything, because a repair on one flue can change the draft in another.
Probably not a full liner, and the camera will tell you which. Coal-era flues in Flatbush are often oversized or unlined for a modern gas boiler, which can cause condensation and spillage. A qualified technician checks liner sizing and tests the draft; if the flue interior is deteriorated, HeatShield ceramic resurfacing or a DuraFlex reline fixes it. Call (855) 301-8570 for an exact quote. Estimates are free.
Because damp summers keep moisture in the brick and frost pushes it out. Flatbush’s humid weather drives water into exposed mortar and brick, accelerating spalling and spreading the failure down the stack. Repointing and waterproofing the stack when the damage is small is what stops it before a rebuild is needed.
A Level 2 inspection goes into the flue interior with a camera, plus the accessible parts of the chimney, crown, flashing and attic or basement connections. For a Flatbush rowhouse with a rear-extension boiler flue, it shows how the appliance connects to the chase and whether a neighbor’s flue runs alongside yours. You get the photos, and we tell you what we find.
Yes, usually without a full scaffold. A crown or flashing repair on a Flatbush rowhouse can almost always be done from the roof with the right access, because the work is at the top of the stack, not the side of the building. On a shared party-wall stack we plan the job so we don’t disturb neighbors, and we say so in the written estimate before booking.
If your Flatbush chimney has a cracked crown, leaking flashing, spalling brick or a shared flue with a neighbor’s boiler, call Chimney Sweep Williamsburg at (855) 301-8570 for a free estimate. We tell you what we find and why it matters, and nothing gets recommended without camera evidence you can look at yourself. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Williamsburg.